| CAUTION
BEFORE INSTALLATION: |
|
- Please,
do not plug in before installation.
- If
you need an electric power system or
extension, please consult a qualified
electrician.
|
|
|
1.
Shut
off the water supply to the existing toilet tank
by closing the angle stop value. Drain the
toilet tank completely. Remove the water supply
hose to toilet tank.
|
2.
Removing
the existing seat and lid.
· By
using a wrench (spanner) or other proper tool,
release the nut on both sides of existing toilet
to remove the toilet seat and lid.
|
 |
 |
| |
|
|
3.
Connect
T-valve.
· Remove
existing supply tube from fresh tank.
· Angle
Stop Valve is standard 1/2" in size. If it
is 3/8" use the 1/2" to 3/8" nut
kits with packing before connecting the Angle
Stop valve. Install T-Valve on top of Angle Stop
Valve.
|
4.
One
of flexible tube connects from top of T-Valve to
toilet tank.
|
 |
 |
| |
|
|
5.
Place
bolt guide with bolt in quick release plate and
slide into designated groove at rear bottom of
main body.
|
6.
Place
main unit aligning to toilet seat mounting
holes.
|
 |
 |
| |
|
|
7.
Securely
tightening mounting bolts with supplied cone
packing and plastic washer.
|
8.
Connect
water supply flexible hose to the unit.
|
 |
 |
| |
*
Connect ground wire from T-Valve to BIO-BIDET
(SUPREME BIDET SEAT)
* Check for any water leakage.
|
9.
Insert
the deodorant catalyst into the unit. |
|
| |
|
| How
to change the deodorant catalyst |
| |
| 1.
Check the deodorant package. |
 |
| 2.
Follow
the below photos to change the deodorant. |
 |
| 3.
Insert
the new deodorant case into the unit. |
 |
| |
|
|
10.
Installation
of Remote Control.
|
|
 |
 |
